OK Deck Mast Bearing

Post your requirements here
corkman
Posts: 30
Joined: Thu Mar 04, 2010 7:13 pm

Re: OK Deck Mast Bearing

Post by corkman » Wed Sep 19, 2012 2:34 pm

sorry for the delay. Been away sailing!!!!!
Top Bearing is c.98mm by 38mm deep.
Also have bottom bearing c.77mm by 49mm deep

Bolt holes on top bearing plate for bolting to deck are at c. 170 mm centres

If you are still interested, pls let me know.
Regards, Craig

Rich
Posts: 88
Joined: Mon May 15, 2006 10:02 pm
Location: United Kingdom

Re: OK Deck Mast Bearing

Post by Rich » Tue Sep 25, 2012 8:03 am

Hi Craig, many thanks for the reply.

Whilst you were away I have managed to fashion up a top bearing from a plastic chopping board and a piece of scrap tufnol that I found. The hole diameter I cut was 98mm and so it sounds like your bearing would be ideal if this one proves no good. I'm currently in the process of repairing the centreboard and rudder but will try to get the boat on the water before the season end. Will let you know how I get on and once again thanks for coming back.
Rich

Post Reply